In recent weeks we have been developing a new brass door knocker design in our small foundry. I have been directly involved with the entire process.

The first step was to design the door knocker we wanted to make. In this case it is an inverted urn design about 7-1/2″ tall. Being engravers we wanted 2 large areas where we could do our personalization work.

When we completed our design the pattern had to be made. This is the piece that will be duplicated in the molding process. We carved a detailed door knocker out of wood to serve this purpose. Two pieces were required, one for the clapper and one for the door knocker body.

When the pattern is completed we can make our sand mold. This involves packing sand very tightly into a two part box with the pattern in the middle. When the box is opened and the pattern taken out it leaves a cavity where it was for us to pour our brass into.

Of all the foundry experiences the most exhilarating is the actual pouring of the brass into the mold.  Our furnace heats the brass until it melts into a liquid. Once it is liquid it must be heated more to get it hot enough to pour completely filling the cavity left by our pattern in the sand.

At this point the crucible containing our hot brass is lifted out of the furnace using a special handle and gloves. We are talking really hot here. Nearly 2000F.

With great care we pour our liquid brass into the mold.

Now we must wait until the brass solidifies in the mold. When that is done we can break away the sand and there is our part.

If all went well there will be no flow marks or voids in the casting and it can be taken to the finishing department where it will be ground and polished into a finished part.

Over the years I have worked on thousands of brass door knockers. This was the first time I experienced the actual birth of one.

It is hard to describe all this in words. We have added some pictures to the site starting at this page

click here for foundry page

from there you can follow the links at the bottom of the page.